Hi.
Is this possible? I have Delphi 10.2 installed, along with D5. Is it possible to install richview ONLY for 10.2 but not touch the D5 installation at all? If so, how?
Thank you
Installing for ONLY ONE version of Delphi?
-
Sergey Tkachenko
- Site Admin
- Posts: 17267
- Joined: Sat Aug 27, 2005 10:28 am
- Contact:
Re: Installing for ONLY ONE version of Delphi?
When running Setup, just uncheck Delphi 5. Delphi 5 will not be affected.
However:
- when uninstalling, it uninstalls TRichView from all Delphi versions.
- if you run "Install TRichView in Delphi IDE" shortcut in the Start menu and uncheck "Delphi 5", TRichView will be uninstalled from Delphi 5.
However:
- when uninstalling, it uninstalls TRichView from all Delphi versions.
- if you run "Install TRichView in Delphi IDE" shortcut in the Start menu and uncheck "Delphi 5", TRichView will be uninstalled from Delphi 5.
Re: Installing for ONLY ONE version of Delphi?
Hi
Sorry, there is no list of installations to uncheck (D5). I just ran the installation again (and cancelled immediately)
And it does not show anything about "uninstall"
Also I noticed that while running install.exe, in the same folder now there is another file "TRichView18Setup18.0.1.exe". Should perhaps run that executable instead? Or is that just a temporary file used by install.exe?
Thanks
Sorry, there is no list of installations to uncheck (D5). I just ran the installation again (and cancelled immediately)
And it does not show anything about "uninstall"
Also I noticed that while running install.exe, in the same folder now there is another file "TRichView18Setup18.0.1.exe". Should perhaps run that executable instead? Or is that just a temporary file used by install.exe?
Thanks
Re: Installing for ONLY ONE version of Delphi?
OK I solved it. I unselected "install IDE", then i went and executed "IDEInstall.exe" and there appeared the list of installed delphi versions.
Thanks.
Thanks.